S&A chiller for SPI 1,2,3,4 kW fiber laser source
Posted on

A customer is from Hungary who is seeking a suitable chiller for SPI 1,2,3,4 kW fiber laser source.

Below is the chiller-laser matches we recommend:
S&A Chiller CW-6100AT: for cooling SPI 1kW fiber laser
S&A Chiller CW-6300AT: for cooling SPI 2kW fiber laser
S&A Chiller CW-7300ET: for cooling SPI 3kW fiber laser
S&A Chiller CW-7800ET: for cooling SPI 4kW fiber laser
Above chiller models are equipped with a automatic heating device, when the water temperature is under/reach target water temp, it will switch on/off automatically.
And they all have ion monitors and filtrating set. Except CW-6100ATH, the other three also have ModBus-485 communication interface.
S&A chiller temperature control range is 5C-35C and the product warranty is 24 months.
Expect a further cooperation with the customer.
Know more about S&A chiller: http://
chiller

CONTACT S&A

TEL:+86-20-89301885,

FAX:+86-20-84309967

SKYPE: teyuchiller

Email:

Website: http://


Anti-wear Ring

Installation and precautions of track connecting rod oil seal
The installation steps for the track link oil seal are as follows:
1. Cleaning: Clean the connecting parts to ensure that the surface is flat, clean, and free of grease and dirt.
2. Oil application: Apply a layer of lubricating oil to the connecting parts for better installation.
3. Installation: Gently push the oil seal into the connection area to ensure that the lip of the oil seal is not damaged.
4. Positioning: After positioning the oil seal, press it with your fingers to ensure it is in the correct position.
5. Inspection: Check if the oil seal is installed correctly and ensure that the lip is not damaged.
The precautions are as follows:
Before installation, check if the oil seal is damaged. If the oil seal is damaged, replace it with a new one.
Before installation, ensure that the surface of the connecting parts is flat, clean, and free of grease and dirt.
3. When installing the oil seal, gently push in to avoid damaging the lip of the oil seal.
4. After installation, check whether the oil seal is installed correctly to ensure that the lip is not damaged.
5. During use, the condition of the oil seal should be regularly checked. If any damage or wear is found, the oil seal should be replaced in a timely manner.

Wear ring for excavator,For excavator track,For excavator accessories

Safe Seal Technology Co., Ltd. , https://www.jsspreals.com