BBQ grill wire mesh is made of
stainless steel wire ,carbon steel wire and galvanized wire .The mesh can be stainless
steel woven wire mesh and welded wire mesh.The BBQ grill wire mesh we can support disposable
and recycle with various shape ,such as round,square,rectangle,the special size
and shape can do customized as well.
The BBQ grill wire mesh widely
used in camping, travel, restaurants and other places for baking and roasting
fish, vegetables, meat, seafood and other delicious food.
The features of the recycle
barbecue grill mesh are corrosion and rust resistance, durability and
environmental friendly.
Bbq Grill Wire Mesh,Bbq Wire Mesh,Barbecue Wire Mesh,Bbq Wire Net Suzhou Haoxiang Screen Stencil Products Co.,Ltd , https://www.shaiwanghaoxiang.com
2. Prior to the operation of the machining center, protective equipment should be worn and the cuffs should be tied. No shawls, gloves, ties, and aprons are allowed; female workers should be carried in hats.
3. Check whether the tool compensation, machine zero point, workpiece zero, etc. are correct before starting the machining center.
4. The relative position of each button should meet the operating requirements. Carefully prepare and input numerical control programs.
5. To check the operation status of the protection, insurance, signal, position, mechanical transmission, electrical, hydraulic, digital display, etc., on the machining center, cutting can be performed under all normal conditions.
6. Before the machining center is commissioned, the operating conditions of the lubrication, mechanical, electrical, hydraulic, and digital display systems should be checked. Cutting operations can be performed under all normal conditions.
7. After the machining center enters the machining operation according to the procedure, the operator is not allowed to touch the moving workpiece, the tool and the transmission part, and it is forbidden to transfer or take tools and other articles across the rotating part of the machine tool.
8. When the machining center is adjusted, the workpieces and tools are clamped, and the machining center is wiped, it must be stopped.
9. Do not remove iron directly by hand. Use special tools for cleaning.
10. When abnormal conditions and alarm signals are found, they should stop immediately and ask relevant personnel to check.
What are the safety regulations that must be observed when machining centers operate?
1. It is not allowed to leave the work station when the machining center is running. For reasons of leaving, the work bench is placed in the middle position, the tool bar is returned, the parking must be stopped, and the power of the host computer is cut off.