As a part of power lines, power cables are widely used due to their low failure rate, safety, reliability, and flexible outgoing lines. However, if it fails, maintenance is more difficult and dangerous, so special attention should be paid to inspection and testing. Work Precautions The cable to be repaired must be confirmed during work. The cables to be repaired can be divided into two types: Terminal failure and cables with apparent failure points on the surface of the cable body. This type of faulty cable has obvious signs of failure and is easy to confirm The cable surface does not expose the cable at the point of failure. For such faulty cables, besides verifying the data and verifying the cable name, it must be identified by a cable identification device so that it can be distinguished from other live electrical cables in operation, especially when there are many cables in the same section. It is especially important to distinguish between cables that need to be repaired and other live cables. At the same time, this can also effectively prevent the cable from being mistaken for the wrong identification of the cable tag, resulting in accidental accidental live cable accidents. Saw cables must have reliable safety protection measures. Before sawing the cable, it must be confirmed that it is a cable that needs to be cut off and that the cable is not energized. Then, it can be worked by grounding the iron core with a wooden handle ( preferably a epoxy handle ) into the cable core. Persons who support wooden handles should wear insulating gloves and stand on insulating mats. Special care should be taken to ensure that the iron brazing is well grounded. (2) If you need to move cables during work, you should be careful not to be reckless and prevent damage to other running cables. The cable head must be installed according to the process requirements to ensure quality and avoid hidden troubles. After the cable is repaired, the phases of the two ends of the cable should be carefully checked. The original phase mark should be removed first, and then the correct phase mark should be put in order to prevent confusion between the old and the new.
Plate is manufactured by depositing chromium-rich, abrasion-resistant materials on mild steel base plate using a traditional arc welding process. This product is usually referred to as chromium carbide overlay (CCO) plate on the market. The hardfacing overlay is suitable for severe abrasive wear and impact applications. Qingdao HART Industrial Technology Co., Ltd was established in 2003, it had a long history of providing innovative wear solution and world class wear products. CCO Hardfacing Grinding Table,Chromium Carbide Grinding Table,Bimetal Composite Ginding Lining,Hardfacing Overlay Grinding Liner SHENYANG HARD WELDING SURFACE ENGINEERING CO.,LTD , https://www.hardfacingplate.com
The ultimate hardfaced product for your application depends on the material--whether rock, sand, gravel or other substance--striking or sliding along the surface of your wear part. It also depends on the angle and speed of impact as well as the operating temperature.
Mostly supplied in segmented parts, occasionally as monobloc casting, the grinding table receives the material grinding bed submitted to the tires pressure as per the vertical mill working principle. Hence those parts need outstanding wear resistance.
Matters needing attention when overhauling and testing power cables